The Ford Barn

flathead48 · 05-25-2023, 08:52 AM

Opinions, is this junk or useable, couple light rust spots, my main concern is wear on teeth.thanks

19Fordy · 05-25-2023, 09:32 AM

Looks NOS and very usable to me. Experts will know more.

flathead48 · 05-25-2023, 11:17 AM

19forty, it came out of a used tranny, thanks

cas3 · 05-25-2023, 11:44 AM

look inside at the bearing surfaces

flathead48 · 05-25-2023, 03:16 PM

Will do thanks cas3

Ken/Alabama · 05-25-2023, 07:43 PM

Sponsored Links (Register now to hide all advertisements)

My way of thinking is this. As much trouble it is to get there I’d replace it then you have no worries. But that’s just me.

Mac VP · 05-25-2023, 07:57 PM

The pictures are a bit fuzzy and don’t show all sides of each gear section, but if the gear teeth are all very similar to what we can see, I believe that gear is very usable. Provided the inside bores (where the roller bearings ride) are not scuffed or pitted.

flathead48 · 05-26-2023, 05:38 AM

Thanks to all, the inside bore is very smooth, I was trying to show the worst side with couple specs of rust .

05-25-2023, 09:32 AM	#2
19Fordy Senior Member Join Date: May 2010 Location: Coral Springs FL Posts: 10,950	Re: Cluster Looks NOS and very usable to me. Experts will know more. Last edited by 19Fordy; 05-25-2023 at 10:23 AM.

05-25-2023, 11:17 AM	#3
flathead48 Senior Member Join Date: May 2010 Location: Saratoga Springs, NY Posts: 1,111	Re: Cluster 19forty, it came out of a used tranny, thanks

05-25-2023, 11:44 AM	#4
cas3 Senior Member Join Date: Jan 2011 Location: sw minnesota Posts: 4,578	Re: Cluster look inside at the bearing surfaces

05-25-2023, 03:16 PM	#5
flathead48 Senior Member Join Date: May 2010 Location: Saratoga Springs, NY Posts: 1,111	Re: Cluster Will do thanks cas3

05-25-2023, 07:43 PM	#6
Ken/Alabama Senior Member Join Date: May 2010 Location: Alabama Posts: 3,261	Re: Cluster Sponsored Links (Register now to hide all advertisements) My way of thinking is this. As much trouble it is to get there I’d replace it then you have no worries. But that’s just me.

05-25-2023, 07:57 PM	#7
Mac VP Senior Member Join Date: May 2010 Location: Cincinnati, OH Posts: 1,361	Re: Cluster The pictures are a bit fuzzy and don’t show all sides of each gear section, but if the gear teeth are all very similar to what we can see, I believe that gear is very usable. Provided the inside bores (where the roller bearings ride) are not scuffed or pitted. __________________ VANPELT SALES LLC Cincinnati, Ohio Office: 513-724-9486 www.vanpeltsales.com www.classictransmission.com

05-26-2023, 05:38 AM	#8
flathead48 Senior Member Join Date: May 2010 Location: Saratoga Springs, NY Posts: 1,111	Re: Cluster Thanks to all, the inside bore is very smooth, I was trying to show the worst side with couple specs of rust .