|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
09-10-2022, 10:25 AM | #1 |
Member
Join Date: May 2010
Location: taneytown Md
Posts: 92
|
removing pan from '48 Merc engine
Can't remove pan from '48Merc. engine which is in '40 Ford STD.2 dr. In side of pan is hanging up on flywheel , not crank counterweights.
|
09-10-2022, 10:57 AM | #2 |
Senior Member
Join Date: May 2010
Location: Southern Maine
Posts: 1,499
|
Re: removing pan from '48 Merc engine
Can you move the pan around at all?
|
Sponsored Links (Register now to hide all advertisements) |
|
09-10-2022, 03:08 PM | #3 |
Senior Member
Join Date: Jul 2010
Location: 36 miles north of Albany NY
Posts: 2,954
|
Re: removing pan from '48 Merc engine
When I worked on my ‘50 Ford, I had to remove the nut on the front motor mounts and jack up the motor in order to remove the pan.
|
09-10-2022, 06:14 PM | #4 |
Senior Member
Join Date: Feb 2011
Location: Buchanan, MI
Posts: 676
|
Re: removing pan from '48 Merc engine
Have you removed the bolt that is installed from the top at the right rear of the pan ?
|
09-10-2022, 07:26 PM | #5 |
Member
Join Date: May 2010
Location: taneytown Md
Posts: 92
|
Re: removing pan from '48 Merc engine
Thanks for all of your replys, will pass on top the owner
|
09-10-2022, 07:42 PM | #6 | |
Senior Member
Join Date: May 2010
Location: East Shore of LAKE HOUSTON
Posts: 11,115
|
Re: removing pan from '48 Merc engine
Sponsored Links (Register now to hide all advertisements)
Quote:
Pictures BELOW show where this bolt is threaded into pan from TOP side, just above starter Bendix. Coop |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|