12-02-2019, 11:23 PM | #1 |
Senior Member
Join Date: May 2010
Location: Boston North Shore
Posts: 752
|
Valve Grinding
Hi All,
I have been grinding some Model A valves with my valve grinder and am finding by the time I am able to get a clean face there is not a lot of margin left. These are stainless valves with 70k+ miles on the motor but valves have not been ground before. Never had this concern before with flatheads and SBC's, newer motors etc. Anyone else experienced this? Thanks, Steve |
|
|
Sponsored Links (Register now to hide all advertisements) |
|