03-15-2019, 10:03 AM | #1 |
Senior Member
Join Date: Aug 2016
Location: Alberta
Posts: 930
|
'31 welting.
Should there be a beaded welt between the fuel tank and the cowl on the '31's?.
|
03-15-2019, 10:06 AM | #2 |
Senior Member
Join Date: May 2010
Location: Sacramento, CA
Posts: 216
|
Re: '31 welting.
Yes. The bead is smaller in diameter than the bead on the fender welt. It was originally installed prior to painting and ended up being lower body color.
|
Sponsored Links (Register now to hide all advertisements) |
|
03-15-2019, 11:04 AM | #3 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,754
|
Re: '31 welting.
Here's a couple of pictures Marco posted.
Bob |
03-15-2019, 11:57 AM | #4 |
Senior Member
Join Date: Aug 2010
Posts: 260
|
Re: '31 welting.
I just did my 29 cc last night, its called cowl welt, 10', part # a3405cw, theres enough to start at the bottom of a door pillar then up and over the top of tank and down the other side, this one piece, the left over is for the 2 sides. I used a paper hole punch 1/4". I used gas tank anti squeak a9006 only on the front edge where the tank and cowl bolt up.
carry on |
03-16-2019, 07:17 PM | #5 |
Senior Member
Join Date: Aug 2016
Location: Alberta
Posts: 930
|
Re: '31 welting.
Thanks. That is what i thought but wanted to be sure.
|
03-16-2019, 10:25 PM | #6 | |
BANNED
Join Date: May 2010
Location: Walla Walla, Washington USA
Posts: 6,066
|
Re: '31 welting.
Sponsored Links (Register now to hide all advertisements)
Quote:
Pluck |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|