The Ford Barn

Leonard · 03-07-2016, 06:10 PM

I have been looking for parts for my Vicky for 2 years, I have found some parts but am still looking for the proper front seat frames and the latch that holds the rear seat backrest back. Any suggestions where I could find these parts?

Flathead · 03-07-2016, 07:24 PM

Did you try Bert's in Denver?

jm29henry · 03-07-2016, 08:17 PM

Post,an add in the model a want a section they have never let me down even if you need to bump it a couple of times!!!

Leonard · 03-07-2016, 11:17 PM

I have been in touch with Berts in Denver and also have had guite a number of adds in The Ford Barn classifieds but so far not much luck.

Oldbluoval · 03-08-2016, 06:23 AM

Sponsored Links (Register now to hide all advertisements)

The male part is/was available from most suppliers. It is a cast part
The spring recepticle is hard to find but they are around. I'll look
Go direct
[email protected]

03-07-2016, 06:10 PM	#1
Leonard Member Join Date: May 2013 Location: Edmonton, Alberta Posts: 96	Early 1931 Victoria I have been looking for parts for my Vicky for 2 years, I have found some parts but am still looking for the proper front seat frames and the latch that holds the rear seat backrest back. Any suggestions where I could find these parts?

03-07-2016, 07:24 PM	#2
Flathead Senior Member Join Date: May 2010 Location: Southern Maine Posts: 1,499	Re: Early 1931 Victoria Did you try Bert's in Denver?

03-07-2016, 08:17 PM	#3
jm29henry Senior Member Join Date: Sep 2010 Location: michigan Posts: 1,126	Re: Early 1931 Victoria Post,an add in the model a want a section they have never let me down even if you need to bump it a couple of times!!!

03-07-2016, 11:17 PM	#4
Leonard Member Join Date: May 2013 Location: Edmonton, Alberta Posts: 96	Re: Early 1931 Victoria I have been in touch with Berts in Denver and also have had guite a number of adds in The Ford Barn classifieds but so far not much luck.

03-08-2016, 06:23 AM	#5
Oldbluoval Senior Member Join Date: Jun 2015 Location: Signal Mtn, TN (SE TN) Posts: 2,372	Re: Early 1931 Victoria Sponsored Links (Register now to hide all advertisements) The male part is/was available from most suppliers. It is a cast part The spring recepticle is hard to find but they are around. I'll look Go direct [email protected]