|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
02-16-2017, 08:15 AM | #1 |
Junior Member
Join Date: Jan 2017
Posts: 22
|
Wiring harness routing and clips
I'm putting a '31 coupe back together.
Should the wire harness to the passenger side headlight go over, or under the radiator outlet? How many clips should be used along the bottom of the radiator? Under which hood clamp screw should the harness clip be installed to support the harness as it comes forward out of the light switch? What clips should be used, and what are their locations to support the harness as it runs to the rear before and after the driver's side rear engine mount? Thanks, Chris |
02-16-2017, 12:00 PM | #2 |
Senior Member
Join Date: Jun 2014
Location: Land of Lincoln
Posts: 3,131
|
Re: Wiring harness routing and clips
Thanks for posting I am to that point also! As for radiator wiring i think it goes under the outlet and there are clips on the radiator. Wiring run down the frame rail inside, but I don't remember if on the upper rail or lower rail. Thanks again for posting as I need to get the lights working, I haven't had any problems with hand signals yet :-)
|
Sponsored Links (Register now to hide all advertisements) |
|
02-16-2017, 05:42 PM | #3 | ||
Senior Member
|
Re: Wiring harness routing and clips
Quote:
Quote:
__________________
Mark Maron Ill., Region MARC & MAFCA MARC JSC Member MAFFI Trustee National Facebook Admin. https://www.facebook.com/groups/MARC.group/ A7191-Sport Coupe 29 Roadster 29-Town Sedan 29-Original Special Coupe |
||
02-16-2017, 06:48 PM | #4 |
Senior Member
Join Date: Jun 2014
Location: Land of Lincoln
Posts: 3,131
|
Re: Wiring harness routing and clips
Thanks Mark! I have it I need to study it :-)
|
02-17-2017, 12:45 AM | #5 |
Senior Member
Join Date: Jun 2011
Location: Charlottesville, Virginia
Posts: 364
|
Re: Wiring harness routing and clips
Hi Mark,
The JCS is silent on how exactly the wire to the tail light is clipped, how the cowl lights are run in detail... so, I ask the question again...but specifically, how are the cowl lights run from the one sprig from the switch and how are the rear tail / brake light positioned, clamped and fastened. |
02-17-2017, 01:02 AM | #6 |
Senior Member
|
Re: Wiring harness routing and clips
Sponsored Links (Register now to hide all advertisements)
With the others also asking questions in the same subject I failed to notice that the original post was from a first timer. If you are still looking here wk2w please email me and I'll send you the file with what you need as it is too big to post here. Welcome to the Barn and I'm sorry I did not notice.
__________________
What's right about America is that although we have a mess of problems, we have great capacity - intellect and resources - to do some thing about them. - Henry Ford II Last edited by Mike V. Florida; 02-18-2017 at 01:59 AM. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|