|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
04-21-2013, 05:24 PM | #1 |
Junior Member
Join Date: Mar 2013
Location: Murfreesboro, Tn
Posts: 20
|
35-36 rumble parts
City:
Nashville
State:
Tn
I'm looking for some rumble parts. The two metal plates that are attached to each side panel that the cast part bolts too (2 bolts) and the arm goes through it. The plates are attached by 4 rivets or screws. 1 per side I think?
Rumble stop brackets. ( prefer no repops!) Also if anyone knows of a rumble latch housing that the Stryker bolts too. And the two metal straps supports that attach on either side of the latch. Trunk cars do not have these. We're these 35' only? Any leads would be greatly appreciated.
__________________
1936 5w coupe 1969 427 impala conv 1968 427 belair 2 dr post 1969 camaro SS 1969 judge RA 3 1965 GMC crew cab |
04-23-2013, 10:17 PM | #2 |
Junior Member
Join Date: Mar 2013
Location: Murfreesboro, Tn
Posts: 20
|
Re: 35-36 rumble parts
Had a couple responses. Anyone else have some parts laying around??
Thanks!
__________________
1936 5w coupe 1969 427 impala conv 1968 427 belair 2 dr post 1969 camaro SS 1969 judge RA 3 1965 GMC crew cab |
Sponsored Links (Register now to hide all advertisements) |
|
04-26-2013, 12:42 PM | #3 |
Senior Member
Join Date: May 2010
Location: Modesto Ca
Posts: 377
|
Re: 35-36 rumble parts
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|