02-02-2019, 07:05 PM | #1 |
Senior Member
Join Date: May 2010
Location: Lynden, Wa
Posts: 3,552
|
head wedges
Hello,
I just popped the head up a little bit but need wedges to finish the job. Where should I go or should I make some from hard wood? Mike
__________________
1930 TownSedan (Briggs) 1957 Country Sedan |
02-02-2019, 08:52 PM | #2 |
Senior Member
|
Re: head wedges
Yes, make them from h/wood. Take your time and don’t pinch your fingers. As soon as you get it a little up, slide some blocks under it. It can flatten your fingers
|
Sponsored Links (Register now to hide all advertisements) |
|
02-02-2019, 10:29 PM | #3 |
Senior Member
Join Date: Feb 2011
Location: Lincoln, Nebraska
Posts: 1,909
|
Re: head wedges
Remember not to drive the wedges into the valves.
__________________
Dave / Lincoln Nebraska |
02-03-2019, 12:34 AM | #4 |
Senior Member
Join Date: May 2010
Location: Lynden, Wa
Posts: 3,552
|
Re: head wedges
Yep have pinched the fingers the last time. Well off to buy some oak or something similar tomorrow.
__________________
1930 TownSedan (Briggs) 1957 Country Sedan |
02-03-2019, 12:57 AM | #5 |
Senior Member
Join Date: Nov 2011
Location: Sonoma, CA.
Posts: 1,497
|
Re: head wedges
You can also buy plastic shims at Home Depot
|
02-03-2019, 08:52 AM | #6 |
Senior Member
Join Date: Dec 2010
Location: FRESNO, CA
Posts: 12,560
|
Re: head wedges
Sponsored Links (Register now to hide all advertisements)
Bill Tricky
__________________
"THE ASSISTANT GURU OF STUFF" |
|
|
Sponsored Links (Register now to hide all advertisements) |
|