Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 11-07-2012, 11:49 PM   #21
dumb person
Senior Member
 
dumb person's Avatar
 
Join Date: Apr 2011
Location: South pacific island
Posts: 1,724
Default Re: Model a hand crank

Quote:
Originally Posted by ba49 View Post
I fractured my foot on my stroked Sportster"....." It would lift me right off the kickstarter if I forgot to retard the timing before kicking it. It didn't have an electric starter. I broke the arch in my right foot when it kicked back. I actually bent 2 stock kick levers 90 degrees "....."
There also used to be a thing called Sportster knee caused by hyper-extending your knee when the kicker ratchet slipped as you jumped on the kicker. I limped for several years after I sold the bike. Aw the good old days"
Bill
i did all that with a 90cc bike.
__________________
<Link> This is how we roll<Link>

"I'm Convinced that no one really reads posts anymore; they just fabricate what they think the post says then ramble on about red herrings."--Bob
Outcasts rules of old cars
#1 Fun is imperative, mainstream is overrated
#2 If they think it is impossible, prove them wrong
#3 If the science says it impossible you are not being creative enough.
#4 No shame in recreating something you never had
#5 If it were not for the law & physics you would be unstoppable
dumb person is offline   Reply With Quote
Old 11-07-2012, 11:55 PM   #22
jkeesey
Senior Member
 
jkeesey's Avatar
 
Join Date: Apr 2011
Location: Glenmoore Pa
Posts: 1,644
Default Re: Model a hand crank

I sold a kid (who am i kidding he was older than i was) an old yamaha bobber and i had to give him a crash course on how to kick start a bike. He left my house still not knowing how to do it but said hed be fine. i got a call 2 hours later that he pulled over just to check everything and he couldnt start it back up.
jkeesey is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 11-08-2012, 12:13 AM   #23
Bill in SoCal
Senior Member
 
Bill in SoCal's Avatar
 
Join Date: May 2010
Location: Claremont, CA 91711
Posts: 244
Default Re: Model a hand crank

Remember - always pull up and never put your thumb around the crank. If you remember - could save you a lot of pain. Happy cranking, Bill
Bill in SoCal is offline   Reply With Quote
Old 11-08-2012, 12:38 AM   #24
1946
Member
 
1946's Avatar
 
Join Date: Jun 2012
Location: Tasmania Australia
Posts: 81
Default Re: Model a hand crank

I kick start the 18' Henderson, Hand swing the prop on the 46' Auster, and hand crank the 29' DA Dodge 6
__________________
Tassie Devil
1946 is offline   Reply With Quote
Old 11-08-2012, 04:35 AM   #25
Christoph
Senior Member
 
Christoph's Avatar
 
Join Date: Oct 2010
Location: Frankfurt am Main in Germany
Posts: 671
Default Re: Model a hand crank

I guess last car to have hand crank was Renault R4 ,
built (in Columbia) till 1991.


Edit
ok - should have read the link first.
Still hand-crank might be available for Lada (will try to find out about).

Last edited by Christoph; 11-08-2012 at 05:07 AM.
Christoph is offline   Reply With Quote
Old 11-08-2012, 09:40 AM   #26
Bruce Lancaster
Member Emeritus
 
Join Date: May 2010
Location: Madison, NJ
Posts: 5,230
Default Re: Model a hand crank

Sponsored Links (Register now to hide all advertisements)
So...anyone know of a post-1948 USA car with crank available???
Bruce Lancaster is offline   Reply With Quote
Old 11-08-2012, 11:52 AM   #27
Tom Wesenberg
Senior Member
 
Tom Wesenberg's Avatar
 
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
Default Re: Model a hand crank

Quote:
Originally Posted by Bruce Lancaster View Post
So...anyone know of a post-1948 USA car with crank available???
My 1950 Studebaker still had the slotted crank bolt, but no hole through the grill for the crank handle to fit.

I hand cranked my 49 Chevy truck a lot, but don't know when the last American car was built to have a hand crank.
Tom Wesenberg is offline   Reply With Quote
Old 11-08-2012, 12:35 PM   #28
juke joint johnny
Senior Member
 
juke joint johnny's Avatar
 
Join Date: Feb 2012
Location: London England
Posts: 908
Default Re: Model a hand crank

Quote:
Originally Posted by Bruce Lancaster View Post
The British in general had little faith in batteries...probably a combo of Lucas batteries and those parking lights they had to leave on.
Along with the cranks, they had hand levers on the fuel pump to prime the works...
I too have some experience flogging Hillman Minxes and Huskies...
Bruce
What about those crazy cup shape battery connectors held on by a self tapping screw!!! You only had to go over a few bumps and they would come loose. Then you had a bad connection and a non starting car no matter how good the battery was!!
I think the British supplied cranks to allmost all the cars untill they got rid of those connectors in the 60's

John Cochran
juke joint johnny is offline   Reply With Quote
Old 11-08-2012, 04:39 PM   #29
BILL WILLIAMSON
Senior Member
 
BILL WILLIAMSON's Avatar
 
Join Date: Dec 2010
Location: FRESNO, CA
Posts: 12,560
Default Re: Model a hand crank

Quote:
Originally Posted by juke joint johnny View Post
Bruce
What about those crazy cup shape battery connectors held on by a self tapping screw!!! You only had to go over a few bumps and they would come loose. Then you had a bad connection and a non starting car no matter how good the battery was!!
I think the British supplied cranks to allmost all the cars untill they got rid of those connectors in the 60's

John Cochran
John,
I had forgotten about those+*%#^%^% battery cable ends! And how about those+*$^%$ Lucas batteries that under a HEAVY load test, one cell would mysteriously SWITCH polarity??? That condition would cause the Dynamo (generator) NOT to charge!! (No wonder I have handsome Grey Hair!!) Bill W.
__________________
"THE ASSISTANT GURU OF STUFF"
BILL WILLIAMSON is offline   Reply With Quote
Old 11-08-2012, 09:57 PM   #30
ba49
Senior Member
 
Join Date: Jun 2012
Location: Sheffield Lake, Ohio
Posts: 137
Default Re: Model a hand crank

Had an old R50 BMW that I could actually start with my hand on the kick starter. Low stock compression. Didn't have to jump on it, just step down on it. My cousin had an old 60s Hilman Husky that we used to crank when the starter broke.
ba49 is offline   Reply With Quote
Old 11-09-2012, 05:42 AM   #31
Christoph
Senior Member
 
Christoph's Avatar
 
Join Date: Oct 2010
Location: Frankfurt am Main in Germany
Posts: 671
Default Re: Model a hand crank

Quote:
Had an old R50 BMW that I could actually start with my hand on the kick starter
@ ba49
Lucky you. R50 is best BMW ever.
You should have kept it.

Im able to hand-kick-start my BMW R26 too.

I got an R100GS (1992) with kick starter on it.
They changed kick-starter-gear-ratio, as 40pound ladies should
be able to use kick-starter too.

40 pound ladies are able to turn engine now
BUT
...even fully-grown man (me) are not able to start the engine anymore.
One kick is around 0,2 of one revolution.


BMW got to get rid of kick-starters back than,
as they forgot how ratio should be
Christoph is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 12:15 AM.