|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
03-09-2021, 01:51 PM | #1 |
Member
Join Date: Dec 2019
Posts: 32
|
exhaust manifolds identification
I have a set of Y-block exhaust manifolds and cross-over that I need help identifying as to fitment. The numbers are EBU-9430-B and EBU-9431-C. They were on a 1954 256 cid Mercury but the Mercury parts manual uses the prefix EBY for 1954 instead of EBU. I am guessing that they may be for a 239 cid, but I cannot translate the U identifier. Help?
|
03-09-2021, 02:10 PM | #2 |
Senior Member
Join Date: Aug 2012
Location: Abq, NM
Posts: 3,607
|
Re: exhaust manifolds identification
|
Sponsored Links (Register now to hide all advertisements) |
|
03-09-2021, 02:24 PM | #3 |
Senior Member
Join Date: Aug 2012
Location: IN A 'GALAXIE' FAR FAR AWAY
Posts: 6,485
|
Re: exhaust manifolds identification
ENGINE SERIES IDENTIFIER -
EBU 1954 239CI PASS CAR (DIF) EBV 1954-55 239CI TRUCK ENGINE (CLV) EBY 1954 256CI FORD PI - 1954 MERC - 1954-55 TRUCK (CLV) That ID SYSTEM was used before FORD went to the P&A SYSTEM 1957-58 on where the CASTING ID NOS Prefix were four character,
__________________
***** We should have a contest. The player has to start at the very last post of a thread & then try to guess what the OP's original question was about ... |
03-09-2021, 04:37 PM | #4 |
Senior Member
Join Date: Dec 2010
Location: p.e.i.
Posts: 1,060
|
Re: exhaust manifolds identification
as far as fit goes they will interchange with all y blocks
|
03-09-2021, 08:46 PM | #5 |
Senior Member
Join Date: Aug 2012
Location: Abq, NM
Posts: 3,607
|
Re: exhaust manifolds identification
But not necessarily into different vehicles, due to the fit around other parts under the hood.
|
03-09-2021, 09:35 PM | #6 |
Senior Member
Join Date: Aug 2012
Location: IN A 'GALAXIE' FAR FAR AWAY
Posts: 6,485
|
Re: exhaust manifolds identification
Sponsored Links (Register now to hide all advertisements)
__________________
***** We should have a contest. The player has to start at the very last post of a thread & then try to guess what the OP's original question was about ... |
03-10-2021, 12:45 PM | #7 |
Member
Join Date: Dec 2019
Posts: 32
|
Re: exhaust manifolds identification
Thanks for all of the comments. I can now be fairly certain to market them as 1954 Ford 239 while still fitting a 256, 272, and 292, depending on which heads match with the size of openings.
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|