|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
04-22-2019, 09:37 AM | #1 |
Senior Member
Join Date: Jul 2010
Location: upstate NY near Mass border
Posts: 789
|
Differental rebuild
I am trying to drive out the bearing race on the inboard of the axle housing. I am using the recommended 1/2 inch pipe but I can't seem to keep it on the back side of the race . It is very hard to find the inboard lip on the race with the 3 foot long pipe. Any ideas out there? Also on the outer side of the axle housing there appears to be a bushing on the inside of the housing. Is that correct and if so what is it there for? Jack
|
04-22-2019, 09:39 AM | #2 |
Senior Member
Join Date: May 2010
Location: Auburn Washington
Posts: 2,552
|
Re: Differental rebuild
if you have a welder, run a bead on the inside of the race let it cool. they come out pretty easy.
|
Sponsored Links (Register now to hide all advertisements) |
|
04-22-2019, 10:46 AM | #3 | |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,757
|
Re: Differental rebuild
Sponsored Links (Register now to hide all advertisements)
Quote:
Probably the axle seal. |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|