|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
02-28-2017, 06:47 PM
|
#1 |
|
Junior Member
Join Date: Nov 2013
Posts: 7
|
1931 Town Sedan A-160B
I purchased the above car. I just discovered that there are no body blocks in this car. I am able to purchase body block and bolt kits from suppliers. My question is where do I find the shape of each body block required and the location it is to be mounted into? I also need to know how to mount each body block into its location. Where do the rubber pads go in relation to the blocks? Also, how do I raise the body to install the body blocks? I am at this point in going thru the car and would like to start soon.
|
|
|
|
02-28-2017, 09:40 PM
|
#2 |
|
Senior Member
Join Date: May 2010
Location: Portland OR
Posts: 6,347
|
Re: 1931 Town Sedan A-160B
Taylor welcome to the Ford Barn. You need to post your question on the Model A forum not here. This section is for questions to the editors about the site not car questions.
__________________
I know the voices aren't real but damn they have some good ideas! 
|
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
03-02-2017, 05:01 PM
|
#3 |
|
Junior Member
Join Date: Nov 2013
Posts: 7
|
Re: 1931 Town Sedan A-160B
Sponsored Links (Register now to hide all advertisements)
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 07:38 AM.