The Ford Barn

Mart · 08-05-2022, 01:57 PM

Lots of machining and dodgy welding this week.
Getting the drive from the Laycock overdrive output shaft out into the Early Ford UJ. Hope those welds hold up..

https://youtu.be/Qtfrqffr6Hs

deuce5wndw · 08-05-2022, 05:41 PM

Good job Mart!

Mart · 08-05-2022, 06:25 PM

Thanks Deuce.

cadillac512 · 08-05-2022, 10:09 PM

If you'd quit building those souped up engines there'd be no worry over the welds.

Well done!

Terry

marko39 · 08-06-2022, 09:07 AM

When you get the swap done I bet mph at Pendine.

marko39 · 08-06-2022, 09:07 AM

Sponsored Links (Register now to hide all advertisements)

That’s 100 mph!

08-05-2022, 01:57 PM	#1
Mart Senior Member Join Date: May 2010 Location: Solihull, England. Posts: 8,754	Jeez, is it part 6 already? OD Output shaft to Ford UJ. Lots of machining and dodgy welding this week. Getting the drive from the Laycock overdrive output shaft out into the Early Ford UJ. Hope those welds hold up.. https://youtu.be/Qtfrqffr6Hs

08-05-2022, 05:41 PM	#2
deuce5wndw Senior Member Join Date: May 2010 Location: Liberty, KY Posts: 901	Re: Jeez, is it part 6 already? OD Output shaft to Ford UJ. Good job Mart!

08-05-2022, 06:25 PM	#3
Mart Senior Member Join Date: May 2010 Location: Solihull, England. Posts: 8,754	Re: Jeez, is it part 6 already? OD Output shaft to Ford UJ. Thanks Deuce.

08-05-2022, 10:09 PM	#4
cadillac512 Senior Member Join Date: Apr 2019 Location: Kansas Posts: 921	Re: Jeez, is it part 6 already? OD Output shaft to Ford UJ. If you'd quit building those souped up engines there'd be no worry over the welds. Well done! Terry __________________ "It don't take but country smarts to solve the problem" (Smokey Yunick) '41 Merc Town Sedan / 260" 8CM engine '66 Fairlane four door / "warmed up" 302

08-06-2022, 09:07 AM	#5
marko39 Senior Member Join Date: Oct 2016 Location: harpursville ny Posts: 1,040	Re: Jeez, is it part 6 already? OD Output shaft to Ford UJ. When you get the swap done I bet mph at Pendine.