10-11-2012, 10:26 AM | #1 |
Senior Member
Join Date: Jul 2011
Location: shelby, nc
Posts: 201
|
zinc plug
any suggestions on the best way to remove the zinc plug at the top of a 29 steering column? Mine is really in there!
TD |
10-11-2012, 12:17 PM | #2 |
Senior Member
Join Date: May 2010
Location: Sun City West, AZ
Posts: 489
|
Re: zinc plug
Slide a piece of conduit into the column from the bottom. I use a chunk of galvanized pipe that used to keep the sag out of the middle of my grandmother's clothesline. Bounce the column on the pipe. A piece of 2X keeps the noise down and protects your garage floor. You won't have to pogo it very long before the bushing will pop out.
|
Sponsored Links (Register now to hide all advertisements) |
|
10-11-2012, 04:51 PM | #3 |
Senior Member
Join Date: May 2010
Posts: 1,369
|
Re: zinc plug
I ran an axle shaft up from the bottom and gave it some whacks with a big hammer. Some have two little screws holding it in, others have a "v" notch.
|
10-11-2012, 05:11 PM | #4 |
Senior Member
Join Date: Jul 2011
Location: shelby, nc
Posts: 201
|
Re: zinc plug
Sponsored Links (Register now to hide all advertisements)
TD |
|
|
Sponsored Links (Register now to hide all advertisements) |
|