|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
04-23-2019, 07:26 PM | #1 |
Junior Member
Join Date: Feb 2011
Location: Binghamton NY
Posts: 5
|
Oil pan gasket 59 ab
I've seen in other posts about installing new oil pan gaskets, even a thread with a few pix, & so far, I installed the rear cork fine, I put the front rope into the pan, but not sure about what's been said, to leave 3/64 at the ends. The main pan gasket goes all the way and covers the end of the rope, so why wouldn't I just cut the rope even with the pan flange? And I saw where a bit of white lithium grease was put on the rope during install?
Thanks in advance for any help with this. |
04-23-2019, 07:32 PM | #2 |
Member Emeritus
Join Date: Nov 2012
Location: Wichita KS
Posts: 16,132
|
Re: Oil pan gasket 59 ab
The ends of the rope seal needs to extend above the casting/pan surfaces. It forces the seal to compress when assembled.
|
Sponsored Links (Register now to hide all advertisements) |
|
04-23-2019, 08:54 PM | #3 |
Junior Member
Join Date: Feb 2011
Location: Binghamton NY
Posts: 5
|
Re: Oil pan gasket 59 ab
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|