|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
08-02-2023, 07:52 PM | #21 |
Senior Member
Join Date: Jan 2021
Location: Waynesboro Va.
Posts: 216
|
Re: Diagram to make terminal box switchable
That's a nice setup Y-Blockhead!
|
08-07-2023, 08:30 PM | #22 |
Senior Member
Join Date: Jan 2021
Location: Waynesboro Va.
Posts: 216
|
Re: Diagram to make terminal box switchable
Thanks for everyone's input! I was able to work on it this weekend and got it taken care of! Everything works fine and the gauge is cut off by the switch, which is what I was hoping for. Next step will be to add a fuse block like shown above. I like how it is set up!
|
Sponsored Links (Register now to hide all advertisements) |
|
08-09-2023, 03:09 PM | #23 |
Member
Join Date: Oct 2019
Location: Central Shenandoah Valley,Waynesboro,Va.
Posts: 93
|
Re: Diagram to make terminal box switchable
The factory pop out switch is not an on/off switch you can easily access made to deter theft, you can see only one wire goes in the out wire is in the armored cable. It made the car very hard to hot wire.Theft was bad then too,if you have a motometer it to is theft resistant try to take it off without tools.
__________________
It's not the destination ,it's the journey . |
|
|
Sponsored Links (Register now to hide all advertisements) |
|