|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
01-09-2019, 09:01 AM
|
#1 |
|
Senior Member
Join Date: Mar 2014
Location: Salem, Ohio
Posts: 1,058
|
Machining new batch of Thomas heads.
Since replacing a couple of machining centers I had to set up existing work in other machines. The Thomas heads are one of those jobs. A run of 10 castings was made and I am finally getting them machined this week.
Apparently, my pictures are too large to post here, so visit my Facebook page to see them. Or maybe over on the HAM. Tod |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 05:11 AM.