|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
04-02-2020, 03:39 PM | #1 |
Senior Member
Join Date: Mar 2014
Location: Salem, Ohio
Posts: 1,058
|
Iron Winfield heads back in production.
I had to do some work on the 2nd OP side of the fixture to accommodate the Winfield heads since I have not machined any in this fixture before the two I am machining today. Here is the first one all machined.
The chambers CC at 120cc's including the 4" diameter piston relief that is .045 deep. Unless I am mistaken that is about 7.9:1 ratio with a cylinder bore of 3.975 Tod |
04-02-2020, 03:46 PM | #2 |
Senior Member
Join Date: May 2010
Location: Clinton,WA/Whidbey Island
Posts: 4,104
|
Re: Iron Winfield heads back in production.
Very Nice!
__________________
www.whidbeymodelaclub.com |
Sponsored Links (Register now to hide all advertisements) |
|
04-02-2020, 04:04 PM | #3 |
Senior Member
Join Date: Jan 2012
Location: South Elgin, IL/MID-MO
Posts: 714
|
Re: Iron Winfield heads back in production.
Hello Tod....where can these be purchased, and cost?
|
04-02-2020, 04:14 PM | #4 |
Senior Member
Join Date: Mar 2014
Location: Salem, Ohio
Posts: 1,058
|
Re: Iron Winfield heads back in production.
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|