The Ford Barn

Tinbasher · 07-02-2010, 07:33 PM

Hi Guys: I'm just getting into a 1930 Coupe and I'd like to get the lenght of the 1/4 from the door opening to the rear edge of the rear rail. Someone has put wheelhouse panels into the car and the 1/4s are about 2" longer then the subframe. So some measurements would be handy before I cut out the wheelhouse panels to start again.

The Old Tinbasher

Roger V · 07-15-2010, 01:46 PM

Sponsored Links (Register now to hide all advertisements)

Not particularly timely, but I measured our '31 Coupe which is the same and got "almost" 51 inches. It was difficult as it is together meaning the rear fender is in the way and the rear rail has a contour to it.

07-02-2010, 07:33 PM	#1
Tinbasher Senior Member Join Date: May 2010 Location: Innisfil, Ontario Canada Posts: 1,174	1930 Coupe Quarter Panel Hi Guys: I'm just getting into a 1930 Coupe and I'd like to get the lenght of the 1/4 from the door opening to the rear edge of the rear rail. Someone has put wheelhouse panels into the car and the 1/4s are about 2" longer then the subframe. So some measurements would be handy before I cut out the wheelhouse panels to start again. The Old Tinbasher

07-15-2010, 01:46 PM	#2
Roger V Senior Member Join Date: May 2010 Location: Michigan Posts: 1,593	Re: 1930 Coupe Quarter Panel Sponsored Links (Register now to hide all advertisements) Not particularly timely, but I measured our '31 Coupe which is the same and got "almost" 51 inches. It was difficult as it is together meaning the rear fender is in the way and the rear rail has a contour to it.