|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
06-08-2017, 12:13 PM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: Washington Cty., ME or Flagler Cty., FL
Posts: 1,106
|
Mounting Front Fenders on 1931
Which way are the bolts installed between the front fender and the splash aprons? When looking under the front fender, do you see the nut and washer or do you see the bolt head? Thank you. Would like to do it right the first time! Ed
|
|
|
|
06-08-2017, 12:23 PM
|
#2 |
|
Senior Member
Join Date: Sep 2012
Location: cedar rapids iowa
Posts: 527
|
Re: Mounting Front Fenders on 1931
I put the bolt head on the fender side
|
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
06-08-2017, 03:25 PM
|
#3 |
|
Senior Member
Join Date: Feb 2014
Location: Lake Mills, WI
Posts: 251
|
Re: Mounting Front Fenders on 1931
Ed,
I have a Marc of Excellence winning truck. When looking under the fender, the nuts and washers are visible. Judging Standards state; October 30 thru 31 - Bolts were changed to 5/16"-18 x 3/4" with a 1/2" head, a hex nut, two flat washers (11/16" x 3/4") and a 5/16" lock washer was used at each location. All fasteners were raven finished. Stew
__________________
Always one bad decision away from a good time. |
|
|
|
|
06-10-2017, 08:20 AM
|
#4 |
|
Senior Member
Join Date: May 2010
Location: Washington Cty., ME or Flagler Cty., FL
Posts: 1,106
|
Re: Mounting Front Fenders on 1931
Sponsored Links (Register now to hide all advertisements)
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 03:45 PM.