The Ford Barn

Digger · 06-30-2013, 09:52 PM

Restoring my 36 motor, took the spark plug wires out of the tubes, had the tubes powder coated. Upon putting the wires back in, I had forgot to label which wire set was which. What is the best way to tell how to get them back on the proper side?

Brendan · 06-30-2013, 10:17 PM

Hope this helps...Brendan

ken ct · 06-30-2013, 11:18 PM

Good diagram,but make sure you are looking at the terminal cap from the outside when inserting wires. I solder the little butter fly clips to the plug wire. ken ct. And use the rubber boots that slide up into the metal tubes.

dean333 · 06-30-2013, 11:52 PM

Ken, you're supposed to be sleeping by now! 5am comes quick!

Lawson Cox · 07-01-2013, 01:19 AM

Who can sleep. I am getting to where I cannot go to sleep at night and I am usually up till 3 or 4 before I can get to sleep.

ken ct · 07-01-2013, 03:17 AM

Sponsored Links (Register now to hide all advertisements)

Quote:

Originally Posted by dean333

Ken, you're supposed to be sleeping by now! 5am comes quick!

Couldn't sleep got up at 12:30 and slept maybe an hour on the couch. I got a big 1/2 hr till the alarm goes off might as well stay up now. I sleep terrible as it is,tonite was the pits. ken ct.And im dieing for a cup of coffee.and something to eat,cant

do either. Aint life great!!

06-30-2013, 09:52 PM	#1
Digger Senior Member Join Date: May 2010 Location: Pacific Grove, CA Posts: 1,210	36 Spark plug wires question Restoring my 36 motor, took the spark plug wires out of the tubes, had the tubes powder coated. Upon putting the wires back in, I had forgot to label which wire set was which. What is the best way to tell how to get them back on the proper side?

06-30-2013, 10:17 PM	#2
Brendan Senior Member Join Date: May 2010 Location: At my kitchen table in Santa Rosa, Ca Posts: 2,903	Re: 36 Spark plug wires question Hope this helps...Brendan __________________ If it would have been a snake it would have bit ya! i can't spell my way out of a paper bag!

06-30-2013, 11:18 PM	#3
ken ct BANNED Join Date: May 2010 Location: stratford,ct Posts: 5,971	Re: 36 Spark plug wires question Good diagram,but make sure you are looking at the terminal cap from the outside when inserting wires. I solder the little butter fly clips to the plug wire. ken ct. And use the rubber boots that slide up into the metal tubes.

06-30-2013, 11:52 PM	#4
dean333 Senior Member Join Date: Jun 2012 Location: Shorewood Illinois Posts: 862	Re: 36 Spark plug wires question Ken, you're supposed to be sleeping by now! 5am comes quick!

07-01-2013, 01:19 AM	#5
Lawson Cox Senior Member Join Date: May 2010 Location: Above the gnat line in Georgia Posts: 7,009	Re: 36 Spark plug wires question Who can sleep. I am getting to where I cannot go to sleep at night and I am usually up till 3 or 4 before I can get to sleep. __________________ Life is like a roll of toilet paper. The closer to the end, the faster it goes. It is better to be seen, than viewed. "We sleep safe in our beds because rough men stand ready in the night to visit violence on those who would do us harm".