Go Back   The Ford Barn > General Discussion > Early V8 (1932-53)

Sponsored Links (Register now to hide all advertisements)

Reply
 
Thread Tools Display Modes
Old 07-18-2011, 05:44 PM   #1
jfcrash
Senior Member
 
jfcrash's Avatar
 
Join Date: Sep 2010
Location: Western NY
Posts: 170
Default 1935 Rear Lamp Wiring Harness Routing

Need help on the routing of the 'rear lamp wiring assy 48-14405' (had none to begin with)......

Goes from fuel tank area...then?? (this is were I heed help)...picks up stop lite switch then forward to lighting harness...... but how??

The 35-36 book is not helping me...

Thanks
__________________
______________________________________________
jfc

I couldn't repair the brakes, so I adjusted the horn louder....
jfcrash is offline   Reply With Quote
Old 07-18-2011, 06:49 PM   #2
Mike in AZ
Senior Member
 
Mike in AZ's Avatar
 
Join Date: May 2010
Location: Waddell, AZ
Posts: 2,540
Default Re: 1935 Rear Lamp Wiring Harness Routing

maybe this diagram will help??..good luck....Mike

http://www.vanpeltsales.com/FH_web/F...ram1936car.jpg
Mike in AZ is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)
Old 07-19-2011, 06:52 AM   #3
wamnram
Senior Member
 
wamnram's Avatar
 
Join Date: May 2010
Location: San Tan Valley, Arizona
Posts: 211
Default Re: 1935 Rear Lamp Wiring Harness Routing

Wires clip to inside bottome of frame flange. From gas tank runs along driver side inner frame rails. Wiring goes under frame where tranny mount is then back up into frame rail to brake light switch. Look close or zoom in on picture and you can see it where it goes under tranny mount. I think it shows this somewhere in the 35/36 book.
__________________
Wayne

Last edited by wamnram; 03-20-2019 at 07:23 PM.
wamnram is offline   Reply With Quote
Old 07-19-2011, 06:57 AM   #4
jfcrash
Senior Member
 
jfcrash's Avatar
 
Join Date: Sep 2010
Location: Western NY
Posts: 170
Default Re: 1935 Rear Lamp Wiring Harness Routing

Thanks Mike, I see that it is routed to the right of the battery, so I guess it is following the cross frame rail.......now I have to figure out which holes it went through in the X-box section without pinching the harness with the brake rods........

Thanks, Jim
__________________
______________________________________________
jfc

I couldn't repair the brakes, so I adjusted the horn louder....
jfcrash is offline   Reply With Quote
Old 07-19-2011, 07:01 AM   #5
wamnram
Senior Member
 
wamnram's Avatar
 
Join Date: May 2010
Location: San Tan Valley, Arizona
Posts: 211
Default Re: 1935 Rear Lamp Wiring Harness Routing

jfc, it goes under the x-box section, not through any holes.
__________________
Wayne
wamnram is offline   Reply With Quote
Old 07-19-2011, 07:14 AM   #6
jfcrash
Senior Member
 
jfcrash's Avatar
 
Join Date: Sep 2010
Location: Western NY
Posts: 170
Default Re: 1935 Rear Lamp Wiring Harness Routing

Sponsored Links (Register now to hide all advertisements)
Wamnran, guess your post came in as I was reponding to Mike,

looking at the 35/36 book now, it does show it going under the x box for 1936....but states in 1935 apperantly it went thru some particular holes in the x box which iis what I need to figure out....at least you have confirmed the routing from the fuel tank....I may just route it as in 36 rather than pinching the cable inside the x box...

Thanks, Jim
__________________
______________________________________________
jfc

I couldn't repair the brakes, so I adjusted the horn louder....
jfcrash is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 04:46 AM.