Go Back   The Ford Barn > General Discussion > Model A (1928-31)

Sponsored Links (Register now to hide all advertisements)

Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 06-30-2020, 10:28 AM   #1
OHV DeLuxe
Senior Member
Join Date: May 2010
Location: Norway
Posts: 289
Default G28T center cam bearing oiling?

I now have my rebuilt G28T block and bottom end on the bench, and as always i go through the oil passage system.
These are as some of you know full pressure B type block, they have a solid top oil pump like commonly used on modified regular A and B blocks.
so my question is how does the center cam bearing get lubrication when the oil pump is sealed of on top and the only hole into the cam bore is where the drive meets the cam, this is above that sealed of level.

OHV DeLuxe is offline   Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Sponsored Links (Register now to hide all advertisements)

All times are GMT -5. The time now is 05:11 PM.