|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
07-09-2020, 02:06 PM | #21 | |
Senior Member
Join Date: May 2010
Location: Wisconsin, USA
Posts: 9,007
|
Re: Pressure plate finger adj
Quote:
And yes, as the disc wears, that dimension will change but should stay fairly even with one another.
__________________
"I can explain it for you. However, I can't understand it for you". |
|
07-09-2020, 03:48 PM | #22 |
Senior Member
|
Re: Pressure plate finger adj
This is the proper rig for setting clutches ,My supplier insisted that unless my fly wheel was faced he could not offer a solution for the jumpy clutch he supplied. I pulled the clutch out and set it up on the jig ,yes one finger was low ,took the jig back to show him ,Woopty doo . I wouldn't trust any one without checking .you could maybe use the diaphragm one ,and a vernier .Ted
Last edited by FlatheadTed; 07-10-2020 at 05:54 PM. |
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|