The Ford Barn

Russ/40 · 07-09-2010, 06:51 PM

Assuming all the sheet metal is ready for assembly, what is the most logical sequence? Do the splash aprons go on first, followed by the body, then the fenders and running boards?
Since the car was a basket case when I got it, and I have never had a model A before my minds eye tells me thats the sequence. Am I correct?

It's a 29RPU

Steve Plucker · 07-09-2010, 06:55 PM

Sponsored Links (Register now to hide all advertisements)

Sounds good to me.

Don't forget the frame webbing which sits down on the upper side of both left and right frame members. This goes first, then the splash aprons.

Pluck

07-09-2010, 06:51 PM	#1
Russ/40 Senior Member Join Date: May 2010 Location: Santee, California Posts: 3,505	Assembly sequence ? Assuming all the sheet metal is ready for assembly, what is the most logical sequence? Do the splash aprons go on first, followed by the body, then the fenders and running boards? Since the car was a basket case when I got it, and I have never had a model A before my minds eye tells me thats the sequence. Am I correct? It's a 29RPU

07-09-2010, 06:55 PM	#2
Steve Plucker BANNED Join Date: May 2010 Location: Walla Walla, Washington USA Posts: 6,066	Re: Assembly sequence ? Sponsored Links (Register now to hide all advertisements) Sounds good to me. Don't forget the frame webbing which sits down on the upper side of both left and right frame members. This goes first, then the splash aprons. Pluck