|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
04-15-2011, 02:34 PM | #1 |
Senior Member
Join Date: Jul 2010
Location: Denver, CO
Posts: 317
|
body/frame welting on a '32
I'm putting the body on my '32 chassis and the welting I'm using needs holes drilled for the bolts to pass thru. I can mark off the holes using the holes in the frame as a guide and drill holes or I can just cut an X about where the holes should be to allow the bolt to pass thru.
Or is there a better way of doing this? |
04-15-2011, 02:38 PM | #2 |
Senior Member
Join Date: May 2010
Location: Central Coast, Calif.
Posts: 839
|
Re: body/frame welting on a '32
Mark your holes out and then use a hollow punch like this:
Worked good for me. Neal |
Sponsored Links (Register now to hide all advertisements) |
|
04-15-2011, 03:01 PM | #3 |
Senior Member
Join Date: May 2010
Location: Idaho
Posts: 150
|
Re: body/frame welting on a '32
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|