11-05-2019, 08:33 PM | #1 |
Senior Member
Join Date: May 2011
Location: SW Virginia near the Blue ridge Parkway
Posts: 674
|
Zenith 2 tip
Rebuilding a few carbs and I came across the odd size 13/32 for the GAV assembly. removed it with a adjustable wrench, but wanted something better. Snap-on and others made a special wrench for this available on ebay etc., but it is about the only use you would have for it. Took some measurements and found that it is only a few flat file strokes away from being a 10MM. Problem fixed no extra expense. Maybe not for the purists, but works for me...
|
11-05-2019, 10:07 PM | #2 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,753
|
Re: Zenith 2 tip
There was a member who made a run of 13/32 sockets for us a few years ago.
https://www.fordbarn.com/forum/showthread.php?t=160740 Bob |
Sponsored Links (Register now to hide all advertisements) |
|
11-05-2019, 10:19 PM | #3 |
Senior Member
Join Date: Dec 2010
Location: Hingham, MA
Posts: 135
|
Re: Zenith 2 tip
Some of the crap off shore wrenches are so bad they fit right out of the cheep plastic holder.
|
11-06-2019, 08:52 AM | #4 |
Senior Member
Join Date: Jul 2010
Location: upstate NY near Mass border
Posts: 789
|
Re: Zenith 2 tip
What happened to the (Haag 1332) wrench? Did he decided to make a few or a large run or none? Do any of you guys know? Jack
|
11-15-2019, 09:30 AM | #5 |
Senior Member
Join Date: May 2010
Location: Washington Cty., ME or Flagler Cty., FL
Posts: 1,106
|
Re: Zenith 2 tip
I picked up an 11 mm. deep socket at Home Depot and it seems like it will do the job. Ed
|
11-15-2019, 08:33 PM | #6 |
Senior Member
Join Date: Jul 2011
Location: Southwestern Connecticut
Posts: 931
|
Re: Zenith 2 tip
Sponsored Links (Register now to hide all advertisements)
Martin 5/16" x 13/32" Wrench Ken
__________________
Style beats speed any day, and with a lot fewer tickets. |
|
|
Sponsored Links (Register now to hide all advertisements) |
|