|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
05-31-2020, 02:15 PM
|
#1 |
|
Junior Member
Join Date: May 2020
Location: Germany, in Coburg (Bavaria)
Posts: 24
|
torque all head nuts
I have a question about torquing the cylinder head nuts after changing the head gasket. I have a copper head gasket.
My workshop says I should torquing the nuts again after about 300 miles. The workshop has torqued with 52 ft lbs (70Nm). Would it be better to tighten the nuts more often, so not to wait 300 miles? Are 52 ft lbs sufficient or maybe almost too much? Last edited by Oberfranke; 05-31-2020 at 03:24 PM. |
|
|
«
Previous Thread
|
Next Thread
»
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 01:10 AM.