|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
09-22-2021, 04:01 PM | #1 |
Senior Member
Join Date: May 2010
Location: Lynden, Wa
Posts: 3,552
|
quick questions
Hi All,
Two quick questions: 1) on the front shocks do I have to elongate the holes or use a dremel and open them up completely and then use a large washer for support? 2) I think it was here where I was trying to figure out what bushings I had on my PS frame bracket and people said that they had been replaced. I have a back up PS system and I need to know if the bushing set up on the idler arm is correct. My center link came with a large bushing and I need to know if I have to remove it. I am leaning towards yes, but before I destroy something I just want to confirm it. 3) also, I am assuming the short bushing gets pressed into the bracket and the long bushing goes into the Center link-correct? Thanks, Mike
__________________
1930 TownSedan (Briggs) 1957 Country Sedan |
|
|
Sponsored Links (Register now to hide all advertisements) |
|