|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
05-21-2018, 03:29 PM | #1 |
Senior Member
Join Date: May 2010
Location: 215 E. 6th Street Northport, Michigan 49670
Posts: 941
|
Rumble seat question
Can anyone advise the correct length of the two screws that attach the two lower brackets on the rumble seat back cushion to the truck lid??
10x32xhow long??? Thanks!!!
__________________
Bob from Northport Northport, Michigan |
05-21-2018, 04:26 PM | #2 |
Junior Member
Join Date: Oct 2013
Location: Tyrone, Georgia
Posts: 28
|
Re: Rumble seat question
I own a 1931 Car with it's original Rumble Seat Cushion and Backrest ; The original screws are #12-24 Round head screws, 5/8 in length.
|
Sponsored Links (Register now to hide all advertisements) |
|
05-21-2018, 07:03 PM | #3 |
Senior Member
Join Date: May 2010
Posts: 332
|
Re: Rumble seat question
I used a round head screw , flat washer , lock washer and probably less than 1 inch long . I would remove it and measure but it is to hard to re-install . Norm
|
05-21-2018, 09:35 PM | #4 |
Senior Member
Join Date: May 2010
Location: Auburn Washington
Posts: 2,552
|
Re: Rumble seat question
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|