This is my first attempt at rebuilding a carburetor. I'm rebuilding a 94 2 barrel carb for a 59 AB engine. I thought everything went just fine until I realized that I have an extra spring. Cannot figure out where it should have been installed. It would have been an original spring and the rebuild kit didn't have a replacement. It's possible that the rebuild kit parts don't require it but I just thought I would go ahead and ask to see if anyone recognizes it. I took the picture along side an economizer valve so that it was easy to see how large it is. Thanks in advance for any assistance anyone can provide, I'm literally learning by trial and error.
001.jpg