|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
10-04-2013, 09:55 PM | #1 |
Junior Member
Join Date: Sep 2013
Location: Dellwood, Minnesota
Posts: 21
|
Success!.....Qualified....
Well, Bob's '31 A started tonight! Sounded and felt smooth while it ran, too. No LOPE to the engine. Didn't want to run long, though, but that may be due more to my clumsy execution of the start-up procedure. And, with the original coil! New high-tension wire, though. I'm re-reading the timing procedure and will run through it again, after replacing the points I think. Don't care for the look of the one's in there. Think I didn't nail the step with removing backlash before tightening the cam bolt down. Also, re-reading the "Start and Driving" procedure. I'm sure I can improve on that. Also plan to pull the carbs for a quick clean and check. Air filter is fine.
Gettin' close!..... Last edited by Tatanka; 10-04-2013 at 11:12 PM. |
10-04-2013, 10:23 PM | #2 |
Senior Member
Join Date: May 2010
Location: Lynden, Wa
Posts: 3,552
|
Re: Success!.....Qualified....
Sponsored Links (Register now to hide all advertisements)
Mike
__________________
1930 TownSedan (Briggs) 1957 Country Sedan |
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|