|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
04-23-2018, 12:25 AM | #1 |
Senior Member
Join Date: Apr 2013
Location: Big pine Ca 93513
Posts: 797
|
32 PU need info on parts
Need info for 32 PU model B..wiring harness, light switch, clutch, thro out bearing, pilot bearing, pressure plate, trans bearings..etc are they the same as Model A ?? and best place to get info of this type..tnx much.sc
|
04-23-2018, 01:02 AM | #2 |
Senior Member
Join Date: Apr 2015
Location: Sweden
Posts: 3,045
|
Re: 32 PU need info on parts
Even if the housing of the gearbox is different it uses the same internal parts so bearings should be the same as any early v8.
If i remember right clutchdisc is also same 9" as v8 or atleast works... Pressureplate is engine related so that would be from the A era. A call to Mac Van Pelt will surely give you solid advice and the parts you need for the gearbox. |
Sponsored Links (Register now to hide all advertisements) |
|
04-23-2018, 06:25 AM | #3 |
Senior Member
Join Date: May 2010
Location: southeastern Michigan
Posts: 10,104
|
Re: 32 PU need info on parts
Except for the arm on the end of the clutch fork shaft on early versions, there's no difference in the clutches of the fours and V8, including the pressure plates.
May I suggest acquiring a '32 chassis parts catalogue reprint? They are inexpensive, readily available, and highly informative. As the catalog covers '28-'32, you'll quickly note which parts are carryover Model A parts and those that are unique to '32. |
04-23-2018, 11:52 PM | #4 |
Senior Member
Join Date: May 2010
Location: Snohomish,WA
Posts: 1,030
|
Re: 32 PU need info on parts
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|