|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
12-14-2014, 10:28 PM | #1 |
Member
Join Date: May 2010
Location: Oklahoma City, OK
Posts: 62
|
Model A connect rod cap
Who can tell me what the original standard dimensions are for the connect-rod cap. The dimension of the space where the bolt goes thru. So many have been ground down to where they cannot be used. Gary
|
12-15-2014, 12:50 PM | #2 |
Senior Member
Join Date: May 2010
Location: 60615,330th Ave.,Clare, Iowa, 50524
Posts: 1,457
|
Re: Model A connect rod cap
Sponsored Links (Register now to hide all advertisements)
Then measure the shim pack, and that is what is missing from the cap. So when putting shims in a rod to use after pouring, that is the amount you will have to use on that rod, and it will very alot from rod, to rod as you have allready said. Some will be .016, and some will be .032, and that is all right. Any more then .032 is a waste of Laminate. A solid brass shim for fill is best, and then a Laminate Herm. |
Sponsored Links (Register now to hide all advertisements) |
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|