|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-01-2021, 05:42 PM | #1 |
Senior Member
Join Date: Jan 2021
Location: Western NC
Posts: 213
|
Replace drag link?
While doing other maintenance I removed the drag link on my coupe. Looks like, a previous owner installed plastic ball seats which are worn/distorted.
My question before ordering a original style rebuild kit is should I replace the drag link? Did people install the Teflon parts to compensate for a worn arm? My arm is straight with a little wear at the pitman arm attach point. Thanks!
__________________
1930 Standard Coupe |
11-01-2021, 09:02 PM | #2 |
Senior Member
Join Date: May 2010
Location: Austin, Texas
Posts: 925
|
Re: Replace drag link?
Teflon Seats are installed to make steering easier. Along with a short pitman arm they significantly reduce steering effort. However, the balls must be perfectly round and should be polished to a very smooth surface. If not, premature wear will occur.
__________________
I noticed the harder I work the luckier I get! |
Sponsored Links (Register now to hide all advertisements) |
|
11-05-2021, 03:56 PM | #3 |
Senior Member
Join Date: Jan 2021
Location: Western NC
Posts: 213
|
Re: Replace drag link?
Any tricks to reinstall the drag link? I am having a tough time getting the arm snapped back over the ball. I have the new springs and cups installed correctly and the end caps threaded in only about 2 turns. Seems like this should be easy but it is fighting me.
__________________
1930 Standard Coupe |
11-05-2021, 09:45 PM | #4 |
Senior Member
Join Date: May 2010
Location: St Charles , Missouri
Posts: 1,998
|
Re: Replace drag link?
Sponsored Links (Register now to hide all advertisements)
Larry |
|
|
Sponsored Links (Register now to hide all advertisements) |
|