The Ford Barn

artron9 · 07-22-2019, 12:48 PM

Sponsored Links (Register now to hide all advertisements)

Hi Guys
I found a loose vac tube under the dash on my 52 Vic. One end, I believe is attached to the vacuum thermostat valve located within the heater plenum on the right side. This tube is 1/4 inch and has a plastic tee inserted the middle of the tube. I cannot figure out where the end of the tube attaches and where the other end of the tee goes.The shop manual and the parts manual do not clearly show these. The parts manual says the tee attaches to the wiper hose and the temperature hose but the schematic does not show this. This is not a critical problem but I would appreciate any advice you have? thanks Ron.

07-22-2019, 12:48 PM	#1
artron9 Senior Member Join Date: Nov 2016 Location: Lexington MA Posts: 133	loose vacuum tube Sponsored Links (Register now to hide all advertisements) Hi Guys I found a loose vac tube under the dash on my 52 Vic. One end, I believe is attached to the vacuum thermostat valve located within the heater plenum on the right side. This tube is 1/4 inch and has a plastic tee inserted the middle of the tube. I cannot figure out where the end of the tube attaches and where the other end of the tee goes.The shop manual and the parts manual do not clearly show these. The parts manual says the tee attaches to the wiper hose and the temperature hose but the schematic does not show this. This is not a critical problem but I would appreciate any advice you have? thanks Ron.