|
Sponsored Links (Register now to hide all advertisements) |
|
|
Thread Tools | Display Modes |
11-12-2023, 10:44 AM | #1 |
Junior Member
Join Date: Oct 2023
Location: Canuckistan
Posts: 21
|
8BA oil pan rear sump mount?
I have this rear pan with 3 & a plate welded to bottom of pan. What did it do, is it for?
|
11-12-2023, 11:19 AM | #2 |
Senior Member
Join Date: May 2010
Location: Coral Springs FL
Posts: 10,977
|
Re: 8BA oil pan rear sump mount?
I have the same rear sump oil pan that I bought in 1964 on my 8BA in my 40. It is a rear sump oil pan that came off a 1949-53 Merc. That pan was needed in order to have tie rod clearance. I welded the lug nut to the oil pan drain bolt to make easier access. Those studs on your pan are for a bracket that mounts there. I think Ford pickups also used it.
Look at these oil pans for comparison. https://www.bing.com/images/search?q...1&disoverlay=1 Last edited by 19Fordy; 11-12-2023 at 11:29 AM. |
Sponsored Links (Register now to hide all advertisements) |
|
11-12-2023, 12:07 PM | #3 |
Senior Member
Join Date: May 2010
Location: Granger (Northern) Indiana
Posts: 1,521
|
Re: 8BA oil pan rear sump mount?
The '48-'52 Ford trucks with the common 3" cast iron 1/2 bell had a rear sump oil pan with a threaded bracket on the lower rear of the sump. Two lower bolts connected the bell through the starter plate to this pan bracket.
The '49-'50 (and some '51) Mercurys with the 3" stamped steel 1/2 bell had the 3-stud bracket on the bottom of the rear sump pan that bolted to an angle bracket on the Merc starter plate. Ford Motor must have felt more support was needed when using these 3" bells. |
11-12-2023, 04:06 PM | #4 |
Junior Member
Join Date: Oct 2023
Location: Canuckistan
Posts: 21
|
Re: 8BA oil pan rear sump mount?
Sponsored Links (Register now to hide all advertisements)
|
|
|
Sponsored Links (Register now to hide all advertisements) |
|