Engine not starting - checked everything - no more idea

[Michael_Velling]

Hello, I need advice or help again - sorry :-)

I have the engine now completely ready good compression and it also turns quite well with the starter. The ignition is on the dot. I have set according to Les Andrews and various Youtube videos. All lines durchgemessen according to the manual of Les Andrews...also everything okay.

But the engine does not start! So the carburetor disassembled and cleaned everything - clean. Set the float level with a glass 5/8 inch test fixture under the upper case. Tightness test done - everything tight and fuel in the chamber.

Now when I start but no fuel arrives at the spark plugs? At least they are not wet, even after a large number of revolutions with the starter. The manifold is new, the connection is tight...but nothing happens. It also sucks, held my hand in front of the carb....

Does anyone have any ideas?

Thanks a lot

Michael

Translated with www.DeepL.com/Translator (free version)