|
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
![]() |
Thread Tools | Display Modes |
![]() |
#61 |
Senior Member
|
![]()
My two cents .Like the others I would avoid any heat related solutions , or if so just solder . JB is probably a good solution but you could consider a high temperature silicone. The gauge is shallow and its on the inlet valve the colder of the two and would have the gasket go into it some what . Dodge has the suggestion that you could most likely feel the most confidence with , decking a block is common on a rebuild these days
Last edited by FlatheadTed; 04-12-2021 at 03:18 PM. |
![]() |
![]() |
![]() |
#62 |
Member Emeritus
Join Date: May 2010
Location: Fitzgerald, Georgia
Posts: 2,204
|
![]()
My solution would likely only be appropriate for me to apply. I, therefore, chose to not comment.
JWL |
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#63 | |
Senior Member
Join Date: Feb 2020
Location: BC Canada
Posts: 573
|
![]() Quote:
![]()
__________________
Sometimes, ingenuity gets in the way of sense and sanity. |
|
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|