clutch fork

[DD931]

I ordered new shafts from Bratton's. They are too large in diameter. I tried driving the pedal shaft into the bell housing with no luck. It only went part way before seizing. I'm now faced with figuring how to get it back out! I don't want to use the old one because of wear at the critical points. Same diameter problem with the throw out bearing shaft. Happily, I am able to use the original. Does anyone know where to find a shaft that fits properly?

[Synchro909]

Originally Posted by DD931

I ordered new shafts from Bratton's. They are too large in diameter. I tried driving the pedal shaft into the bell housing with no luck. It only went part way before seizing. I'm now faced with figuring how to get it back out! I don't want to use the old one because of wear at the critical points. Same diameter problem with the throw out bearing shaft. Happily, I am able to use the original. Does anyone know where to find a shaft that fits properly?

Ditto that. No one sells a pedal shaft AT ALL. Bushes either!

[updraught]

Originally Posted by Synchro909

Ditto that. No one sells a pedal shaft AT ALL. Bushes either!

1928-31 RHD Pedal Shaft A-7506-RH

1 inch diameter pedal shaft for the 1928-31 Right Hand Drive Model A Ford.
There are no specific bushes available for the RHD shaft, but the A-6207 piston con rod bushes can be used, with a small amount of reaming. 4 bushes are required.
Price: £9.96 (£11.95 Incl. vat)

https://www.oneillvintageford.co.uk/..._A_Pedals.html