![]() |
#1 |
Junior Member
Join Date: Feb 2015
Posts: 21
|
![]()
Hello guys,
Just install a Tatterfiels manifold with a Stromberg 97 carb. I now need a bell crank. Is there one being made. |
![]() |
![]() |
![]() |
#2 |
Senior Member
Join Date: Nov 2010
Location: Anchorage, Alaska
Posts: 9,123
|
![]()
My engine builder made and installed mine. (Optional at extra cost, of course. )
__________________
Alaskan A's Antique Auto Mushers of Alaska Model A Ford Club of America Model A Restorers Club Antique Automobile Club of America Mullins Owner's Club |
![]() |
![]() |
Sponsored Links (Register now to hide all advertisements) |
|
![]() |
#3 |
Junior Member
Join Date: Feb 2015
Posts: 21
|
![]()
Thank you Carig. I saw a die cast on e-bay but can't seem to fine it now.
Pictures of yours would be helpful. |
![]() |
![]() |
![]() |
#4 |
Senior Member
Join Date: May 2010
Location: Southern California
Posts: 7,070
|
![]()
Is this what you are looking for: https://www.fordbarn.com/forum/showt...ge#post1628897
Charlie Stephens |
![]() |
![]() |
![]() |
#5 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,833
|
![]()
Here's a picture of one that was on Epay.
Bob |
![]() |
![]() |
![]() |
#6 |
Senior Member
Join Date: Jun 2010
Location: Temecula, CA
Posts: 4,115
|
![]() Sponsored Links (Register now to hide all advertisements)
|
![]() |
![]() |
![]() |
#7 |
Junior Member
Join Date: Feb 2015
Posts: 21
|
![]()
Thanks to all for suggestion. problem making one is the throttle ball .I have look all over for them with no results. Any suggestions?
|
![]() |
![]() |
![]() |
#8 |
Senior Member
Join Date: May 2010
Location: So Cal
Posts: 8,833
|
![]() |
![]() |
![]() |
![]() |
#9 |
Junior Member
Join Date: Feb 2015
Posts: 21
|
![]()
Thank you Bob Just what I need
|
![]() |
![]() |
![]() |
|
|
Sponsored Links (Register now to hide all advertisements) |
|