|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
07-20-2010, 05:54 PM
|
#1 |
|
Senior Member
Join Date: Jul 2010
Location: Denver, CO
Posts: 317
|
Torque Tube & driveshaft shortening
I'm putting a '40 Ford rearend into a completely stock original '32 chassis with a '39 tranny and I need to make a driveshaft and shorten the '40 torque tube. Are there standard dimensions on these 2 pieces since this has been done by many hot rodders over the years that somone could supply me with or should I measure and fabricate anyway?
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 03:43 AM.