|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
02-17-2025, 12:38 PM
|
#1 |
|
Senior Member
Join Date: May 2010
Location: Gwynn's Island Va
Posts: 1,604
|
Water jacket cleaning part 2
Taped all the holes off, hooked up 5hp. Shop vac to water inlet. Remove tape off of 1 hole, scratch around with a screwdriver. Afterwards I ran the magnet into each hole. Results just a tiny amount of debris cam out.
Inside of shop vac tells the story. |
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 01:29 PM.