Leakless water pump question….

[KMBeers]

Ok, I know this topic has been covered in a “bunch” of other times. I am getting ready to start my car after having the engine rebuilt (discussed in another thread), which included replacing the water pump. From Snyders, I chose the A-8502-A Leakless pump and the attached image is the instruction sheet that came with it. My question is does anyone have an image of the seam between the shaft and bushing? I want to know what to look for before I pump grease into thei pump because I have not had one of these apart before. Can I simply back the simulated packing nut out and look for the seam? Perhaps I am over thinking this but I am hoping the experts here on the forum can point me in the right direction.