|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
 |
|
Thread Tools | Display Modes |
05-27-2024, 07:39 AM
|
#1 |
|
Member
Join Date: Jun 2010
Location: New Jersey
Posts: 66
|
Pop out cable data plate install
Hello everyone.
I’m looking to install the patent plate onto my pop out cable on my early ‘30 pick up. It has the small “twisted” rivet. Do I just drill a tiny hole and hammer it home? Or is there another technique? Thanks! |
|
|
|
05-27-2024, 10:13 AM
|
#2 |
|
Senior Member
Join Date: Jul 2010
Location: Pennsylvania
Posts: 1,251
|
Re: Pop out cable data plate install
Yup, drill a hole slightly smaller than the diameter of the rivet and tap the rivet home.
|
|
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
05-27-2024, 05:57 PM
|
#3 |
|
Member
Join Date: Jun 2010
Location: New Jersey
Posts: 66
|
Re: Pop out cable data plate install
Sponsored Links (Register now to hide all advertisements)
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 01:09 PM.