Signal lights

[dlfrisch]

I just installed a new turn-signal unit (Signal Stat series 900 6V). I followed the directions using a eight section terminal block and I can‘t figure out where I went wrong. Temporarily jumping the lighting fixture circuits, they are all correct- right/left- front/rear. The only thing, that is confusing, is that the signal switching schematic shows a center connecting spot on the term block. It shows a [red/green] wire coming out of the signal switching harness and to be connected through to (Signal Stat 900 only) steering column light switch. I’m not sure as to what they want…..

To start with, the new turn signal unit does not have a [red/green] wire coming out of the harness, so that ends that procedure.

Just thought maybe someone may have an idea…..I’m going back out and fuss with it. I do have a good mechanical ground. I installed a separate wire from the new unit on the steering column to the chassis.