The Ford Barn

Jim in S.C. · 03-31-2013, 02:59 PM

Can someone tell me what nails Henry used to hold the alumnium door sills in the A-400 and the Victoria. Are they stainless, what length and what head? Flat or rounded. Where can they be bought?
Thanks, Jim

Arlen · 03-31-2013, 10:45 PM

On our A400 they are dome head. Couldn't say what length but I would think 3/4 inch would be plenty long. Does the A&L sills not come with them?

Jim in S.C. · 04-01-2013, 07:45 AM

Sponsored Links (Register now to hide all advertisements)

Thanks for the reply. I have enough of the round head spiral shank nails to install my new sills. I will install them today.
Jim in S.C.

03-31-2013, 02:59 PM	#1
Jim in S.C. Member Join Date: May 2010 Posts: 72	nails Can someone tell me what nails Henry used to hold the alumnium door sills in the A-400 and the Victoria. Are they stainless, what length and what head? Flat or rounded. Where can they be bought? Thanks, Jim

03-31-2013, 10:45 PM	#2
Arlen Senior Member Join Date: May 2010 Location: Dallas Posts: 524	Re: nails On our A400 they are dome head. Couldn't say what length but I would think 3/4 inch would be plenty long. Does the A&L sills not come with them? __________________ DMAFC

04-01-2013, 07:45 AM	#3
Jim in S.C. Member Join Date: May 2010 Posts: 72	Re: nails Sponsored Links (Register now to hide all advertisements) Thanks for the reply. I have enough of the round head spiral shank nails to install my new sills. I will install them today. Jim in S.C.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode