The Ford Barn

CarlG · 11-03-2014, 03:25 PM

Just curious if any of the Engine Builders have expressed an interest in completing these blocks into short or long block engines? (Rich Fallucca, James Rogers, Ron Kelley, etc.)

Mitch//pa · 11-03-2014, 03:42 PM

i agree with where Carl is coming from.. many of us just want to purchase a ready made long or short block through a supplier with a warranty and not get involved in building it ourselves. my guess this is down the road a little

11-03-2014, 03:25 PM	#1
CarlG Senior Member Join Date: Nov 2010 Location: Anchorage, Alaska Posts: 9,192	Re: New block machining. Just curious if any of the Engine Builders have expressed an interest in completing these blocks into short or long block engines? (Rich Fallucca, James Rogers, Ron Kelley, etc.) __________________ Alaskan A's Antique Auto Mushers of Alaska Model A Ford Club of America Model A Restorers Club Antique Automobile Club of America Mullins Owner's Club

11-03-2014, 03:42 PM	#2
Mitch//pa BANNED Join Date: May 2010 Location: Bucks County, PA Posts: 11,454	Re: New block machining. i agree with where Carl is coming from.. many of us just want to purchase a ready made long or short block through a supplier with a warranty and not get involved in building it ourselves. my guess this is down the road a little

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode