|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
05-26-2014, 01:25 PM
|
#4 |
|
Senior Member
Join Date: Nov 2013
Location: Northern Bucks Co. Pa
Posts: 632
|
Re: Sealing camshaft
You shim where the two top bolts are. Clean off the FW housing and block really good, bolt them up except the two top bolts. Then , with a feeler gauge check the gap, It should be .010. All the shims I have seen for this have been .010. The shims do not hold the FW housing off the block. I don't know what Henry had in mind when he made that surface .010 lower.
Terry |
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 12:49 PM.