|
|||||||
| Sponsored Links (Register now to hide all advertisements) |
|
|
|
Thread Tools | Display Modes |
01-12-2014, 04:43 PM
|
#17 |
|
Senior Member
Join Date: May 2010
Location: Oregon
Posts: 6,370
|
Re: Manufacturing Mistakes on Original Parts
I had a pair of NOS rear hubs that would accept the new bearing but not go on as the finale finish was about .005 too small.
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
| Sponsored Links (Register now to hide all advertisements) |
|
|
All times are GMT -5. The time now is 08:17 PM.